
We had a few days of very high winds in March and April that managed to knock a 2 x 4 piece of lumber and a cinder block into the pool...both items that were helping to hold down the pool cover. When the pool cover doesn't cover, you get....algae! It doesn't show up as clearly here as it does in real life, but you get a picture at the shallow end of the pool of the amount of algae that was growing. We usually could see some algae in the water when we took the pool cover off each spring, but never on the liner like this.
But the real issues was the liner itself! Again, this picture doesn't do justice to how much the liner had pulled away from the sides of the pool. We have no idea why this happened, but replacing the liner alone would have cost at least the same as the demolition....so the decision to remove came at a most opportune time.
We had used our pump to get out most of the water...and then had to pull the cover off from the
shallow end. We were hampered by the fact that by this time, much of the pool cover at the deep end had fallen into the pool....along with VERY heavy water filled tubes that normally hold down the cover. I wish I had a picture of Bob sliding down the pool cover (remember the algae?) holding a pair of scissors to cut the tubes free, and holding on with the other hand to a pole that I was holding from the deck to keep him from falling into the sludge that was still at the bottom. My hero!!!So...most of the leaves are gone, although we're hoping the ones at the very bottom dry out a little more so they are more easily removable.
No comments:
Post a Comment